Post by Deleted on Nov 27, 2017 5:20:21 GMT -5
The 9172 is plugged in, the power applied to the 9172, the PC recognizes the 9172, MAX setup is done with all module recognized.
If the PC power is cycled, windows restarts, the active LED is amber the ready LED is off and the 9172 is no longer recognized until the power to it is cycled or the USB cable is unplugged then plugged in again. If windows is restarted, PC power is not cycled, then the ready LED is amber and the active LED is off. The windows does not recognize the 9172 until the 9172 power is cycled or the USB cable is unplugged then plugged in again. Device Manager does not show the National Instruments icon until the steps to get the 9172 recognized are done. Otherwise Device manager shows unknown device under the USB connections.
Any idea?
Please help.
Thanks!
I didn't find the right solution from the Internet.
References forums.ni.com/t5/Multifunction-DAQ/cDAQ-9172-USB-is-not-recognized-after-PC-power-is-cycled/td-p/847172
Branding Motion Graphics
If the PC power is cycled, windows restarts, the active LED is amber the ready LED is off and the 9172 is no longer recognized until the power to it is cycled or the USB cable is unplugged then plugged in again. If windows is restarted, PC power is not cycled, then the ready LED is amber and the active LED is off. The windows does not recognize the 9172 until the 9172 power is cycled or the USB cable is unplugged then plugged in again. Device Manager does not show the National Instruments icon until the steps to get the 9172 recognized are done. Otherwise Device manager shows unknown device under the USB connections.
Any idea?
Please help.
Thanks!
I didn't find the right solution from the Internet.
References forums.ni.com/t5/Multifunction-DAQ/cDAQ-9172-USB-is-not-recognized-after-PC-power-is-cycled/td-p/847172
Branding Motion Graphics